Obviously, this will only work with the OpenGL "video.driver" setting, and only on cards and OpenGL implementations that support shaders, otherwise you will get a black screen, or Mednafen may display an error message when starting up. Negative values are the same as positive values for non-interlaced video, but for interlaced video will cause the scanlines to be overlaid over the previous(if the interlacer setting is set to "weave", the default) field's lines. Opacity is specified in % IE a value of "100" will give entirely black scanlines. Remove 16-sprites-per-scanline hardware limit. If set, when RUN+SEL are pressed simultaneously, disable both buttons temporarily. One should be conscious of these settings if one has changed them from the default values when using network play or movies, as they can cause desychronizations if not set the same among hosts(or between the recording emulator and the playing emulator). If only 512 triplets are present, the remaining 512 greyscale colors will be calculated automatically.Ĭaution: Any settings that change emulation behavior as seen from the emulated game are shown with the setting name bolded in the table. WARNING: Save states, movies, and netplay are definitely not compatible between the "pce" module and the "pce_fast" module. "-force_module pce_fast" to Mednafen each time it is invoked.
To use this module rather than the "pce" module, you must either set the "pce.enable" setting to "0", or pass Which traded speed away in favor of accuracy). It isĪ fork of 0.8.x modified for speed at the expense of (usually) unneeded accuracy(this compares to the "pce" module,
The "pce_fast" emulation module is an experimental alternative to the pce emulation module.
Mednafen PC Engine (CD)/TurboGrafx 16 (CD)/SuperGrafx Documentation PC Engine (CD)/TurboGrafx 16 (CD)/SuperGrafx Documentation Last updated January 14, 2022